- New
The Warne 721LM 1-inch medium rimfire scope rings mount 1-inch riflescopes to 3/8-inch or 11mm dovetail receivers. These steel Maxima Rimfire rings feature quick-detach levers, a reversible asymmetrical clamp and a 70/30 horizontal split design. The medium profile measures 0.400 inch and accommodates objective lenses in the 20–42mm range, depending on rifle and scope clearance. Matte black finish. Each pair weighs 3.8 oz. Made in the USA.
The Warne 721LM Maxima Rimfire scope rings provide a quick-detach mounting solution for 1-inch riflescopes on rimfire rifles with 3/8-inch or 11mm dovetail receivers. The steel rings use a reversible asymmetrical clamp to fit either dovetail width and a 70/30 horizontal split design to secure the scope tube. Quick-detach levers allow the rings and optic to be removed from the receiver and reinstalled when needed.
This medium configuration has a 0.400-inch Dimension B measurement and is designed for objective lenses in the approximate 20–42mm range. Actual clearance varies with the rifle, barrel profile and scope dimensions. The rings have a matte black finish and weigh 3.8 oz per pair.
The reversible clamp accommodates either common rimfire dovetail width. Check the small alignment dot on the side clamp: with the dot facing up, the rings are configured for a 3/8-inch dovetail; with the dot facing down, they are configured for an 11mm dovetail. Confirm the receiver's actual dovetail size before installation.
The QD levers allow the rings to be detached from the receiver without removing the scope from the rings. When reinstalling, return the rings to their intended position and verify that the scope is secure, the reticle is level and the rifle maintains proper zero before use.
| Manufacturer | Warne |
| Series | Maxima Rimfire |
| Model | 721LM |
| Scope Tube Diameter | 1 inch |
| Ring Height | Medium |
| Dimension B | 0.400 inch |
| Objective Size Range | 20–42mm |
| Mounting Platform | 3/8-inch or 11mm dovetail |
| Mounting Style | Quick detach |
| Ring Design | 70/30 horizontal split |
| Material | Steel |
| Finish | Matte black |
| Fasteners | T-15 Torx |
| Weight | 3.8 oz per pair |
| Country of Manufacture | USA |
Verify that the firearm is unloaded before installation. Warne recommends loosely assembling the rings and scope on the firearm first to check eye relief and ring spacing. Tighten the quick-detach levers finger-tight; do not overtighten them. Warne's published maximum for the ring-cap screws is 25 in-lb on dry threads without thread-locking compound. Follow the scope manufacturer's torque requirements if they specify a lower limit.
For a fixed-mount alternative with the same ring height and 1-inch tube fit, see the Warne 721M fixed rimfire scope rings. Browse the full selection in the Warne Rimfire Scope Rings category.