The Warne 200M Maxima scope rings mount 1-inch riflescopes to Weaver-style cross-slot bases and Picatinny rails. These low-profile, fixed steel rings have a 0.250-inch mounting height and a matte black finish. Integrated square stainless steel recoil-control keys in both rings engage the base slots to help prevent movement under recoil. The vertical split design uses T-15 Torx screws to secure the scope. Designed for objective lenses approximately 20–36mm in diameter. Made in the USA.
The Warne 200M Maxima fixed scope rings provide a secure mounting solution for riflescopes with 1-inch main tubes. Designed for Weaver-style cross-slot bases and Mil-Spec Picatinny rails, these low-profile steel rings use an integrated recoil-control key in both the front and rear ring to help prevent movement under recoil.
The 200M features a 0.250-inch mounting height, measured from the top of the base to the inside bottom of the ring. This low configuration is designed for riflescopes with objective lenses approximately 20–36mm in diameter. Actual clearance depends on the rifle, barrel profile, scope dimensions, and mounting base.
The Warne Maxima fixed ring design uses a square stainless steel recoil-control key in both rings. These keys engage the cross slots in the mounting base to provide positive contact between the rings and rail. This design helps resist movement under recoil and distributes recoil engagement across both mounting points.
The vertically split rings use T-15 Torx socket cap screws to clamp around the riflescope tube. Their steel construction and wider clamping band provide substantial contact around the scope.
The Warne 200M has a 0.250-inch mounting height, measured from the top of the mounting base to the inside bottom of the ring. Its low profile is intended for smaller objective scopes where the rifle's barrel and receiver allow adequate clearance. Check the distance between the scope's objective bell and the barrel before installation. The scope must also clear the bolt, safety, and other firearm components throughout their operation.
| Manufacturer | Warne |
| Series | Maxima Fixed |
| Model | 200M |
| Scope Tube Diameter | 1 inch |
| Ring Height | Low |
| Mounting Height | 0.250 inch |
| Objective Lens Range | Approximately 20–36mm |
| Mounting Platform | Weaver-style cross-slot and Picatinny rails |
| Mounting Style | Fixed |
| Ring Design | Vertical split |
| Recoil Control | Square stainless steel keys in both rings |
| Material | Steel |
| Finish | Matte black |
| Fasteners | T-15 Torx |
| Weight | 4.3 oz |
| Country of Manufacture | USA |
| UPC | 656813000227 |
Verify that the firearm is unloaded before installation. Position the rings and scope on the rifle before final tightening to check ring spacing and eye relief. Make sure both recoil-control keys engage the mounting rail slots properly.
Warne specifies a maximum torque of 25 in-lb for the ring screws on dry threads without thread-locking compound. Follow the riflescope manufacturer's torque requirements if they specify a lower limit. Avoid overtightening screws or allowing the scope's objective bell to contact the barrel or interfere with firearm operation.