UTG PRO POI Picatinny Scope Rings 30mm Medium RWU013015

UTG PRO POI Picatinny Scope Rings 30mm Medium RWU013015

• Center height: 30mm
• Saddle Height: 15mm

Features

• Proudly Designed and Made in USA
• Low Profile P.O.I® (Precision Optics Interface) Rings Have a 30mm Center Height to Fit Optics with a 30mm Tube, and up to a 59mm Outer Objective
• The Innovative P.O.I® (Precision Optics Interface) Addresses 3 of the Most Critical Areas in Scope Rings
  • a) Progressively Machined for a Precise Inner Diameter Scope Interface to Achieve a Seamless Ring-to-Scope Interaction
  • b) Low Profile and Flush-fitting Locking Side Plate Controlled by Dual Spring Loaded Guide Rods Interfacing with the Rail with Torx Screw Locking to Ensure Secure and Repeatable Zero Hold 
  • c) Square-shaped Integral Recoil Stop Interfacing with a Picatinny Slot via Complete Surface Contact to Eliminate the Possibility of Forward and Aft Movement from Recoil Vibrations
• 2 Piece Ring Set, Each Equipped with 4 Top Torx Screws and Designed with a 22mm Ring Width
• Designed to Fit on Mil-spec 1913 Picatinny Rail Platforms
• Machined from 6061-T6 Aluminum Alloy and 4605 Steel with Matte Black Hard Coat Anodize

Manufacturer recommends to tighten the ring top screws with a torque value of about 25 inch-lb and the side plate screw with torque value of about 45 inch-lb.